The heaters also have to comply with an enhanced version of the Electro Mechanical Compatibility Directive to ensure they do not interfere with other electronics and that they are immune from interference by other electronics. Heatsource blown air heaters conform to the latest European standards for both the appliance and the electronics and during the rigorous testing the focus is very much on safety. The micro-processor electronics regulates the motor voltage so that the fan speed does not alter from 10 to 15 volts.
Noise is also unaffected by high voltage, a common occurrence with battery charges, solar panels etc permanently wired. There will always be some air noise from a system that produces a healthy throughput of air, however, by using high quality balanced fans and smooth enclosed motors with ball race bearings, noise is kept to a minimum. Propex heaters are designed to be quiet in operation without compromising air throughput and heat output.
Gas tube heater series#
The HS series heaters are also very efficient on electrical current consumption, the high quality motor/fan combination and innovative current reducing electronics, both of which have been improved in the latest versions, means that even the larger HS2800 draws less than 2 amps during normal operation. To add to the efficiency, cabin air is normally re-circulated in preference to using cold air from outside. The Heatsource units are totally room sealed and exhaust all products of combustion externally through the neat 22mm i.d. Air for combustion is taken from outside and passed into the combustion chamber having been mixed with gas during three aeration stages, it is ignited automatically and heats up the large surface area of the heat-exchanger. With forced air combustion and the Propex two stage stainless steel heat-exchanger, the HS2000 is a clean and highly efficient way to heat your vehicle or boat.
Unlike some heaters, there is minimal electric current consumption during ignition so cycling the Heatsource on and off does not have the effect of additional battery drain. An easy to operate panel mounted digital timer/thermostat specifically designed for Heatsource, is also available.
The thermostat is an easy to fit surface mount design and integrates with the new electronics fitted to the HS2000 and HS2800 heaters. When the room temperature drops below the selected level, the Heatsource will automatically ignite and run until the cabin reaches the selected temperature. The HS20000 is supplied as standard with a solid state electronic thermostat which automatically switches the unit on and off to maintain the desired temperature. With the correct Fitting kit they are also suitable and approved for use in Boats. Both 12 and 24 volt versions are available. Propex Heatsource blown air systems are used in many applications throughout the world, these include Motorhomes, Caravans, Cranes, Horseboxes, Mobile Workshops etc.
0 kommentar(er)
